All-Base Matt Finish Adhesive Roll

Description

SuperTape All-Base Tape Roll

o   Rolls of various lengths 

o   Total value for money and very easy to use

o   You can Swim with it. You can Sweat in it. You can Trek in it.

All-Base Tape is a strong double-sided adhesive tape with a matte finish and slight stretch.

All-Base is formulated to provide a Multi-Week Wear.

Like most of our Multi-Week Wear Tapes, All-Base is best applied ONCE and not attached, removed and then reattached.

When removed, All-Base should leave very little residue making clean-up very quick.

Width : 1 Inch
Length : 12 Yards

This is also used as body tape.

• Skin-safe
• Clear
• Odourless
• Extended wear tape
• Very easy to use

It cleans up easily with your favourite adhesive remover.

We recommend “PURE Adhesive Remover or SAS Adhesive Remover”.

It has a very long-lasting hold time.

Description

Name                    : All Base
Construction             : Double-sided
Comparable              : Unknown
Stretchy                  : Slightly
Performance             : Multi-Week Wear possible
Appearance              : Clear with a matte finish and a white liner
Profile                    : Thin
Adhesive                 : Acrylic
Uses                      : Front, Back and sides for Hair Enhancement
Medical Device          : No
Hypoallergenic          : No

Important Information

Ingredients
All-Base Tape is a clear, odourless, acrylic adhesive that has been enhanced to increase performance and longevity.

Storage
Store away from direct sunlight and excessive temperatures.

Directions

Prep for Install

1. Shampoo the hair system and bio hair with Bond Breaker Shampoo and let dry.
2. Apply 99% Alcohol to the scalp and the base of the system to prepare for optimal adhesion. Allow to completely evaporate.
3. Apply Scalp Protector to the scalp to enhance the tape’s bond strength and shield against skin irritation.

Contours and Minis

1. Peel off the white liner that is scored down the middle.
2. Place the adhesive side toward the unit. Avoid touching the adhesive.
3. Place the tape contour where desired on the hair system.
4. Repeat as needed.
5. When ready to apply to the scalp, peel off the remaining printed liner pieces.
6. For easier application, spray Just-Rite Positioning Spray over the adhesive area. The amount sprayed will determine the amount of time available to adjust the unit (the more you spray, the longer you have until the adhesive grabs).
7. Press the hair system firmly onto the scalp, taking care not to move it in the process.
8. Ultra Hold Tape is best removed with solvent.

Caution 

In case you intend on wearing SuperTape, during cos-play, on stage, at photoshoots, or for any other purpose where a strong, flexible bond is desired, pre-test skin compatibility by placing a small amount of tape on the inside of the forearm for a period of 24 hours.

If irritation develops, discontinue use.